I need help completing Homework #4 for ME 210 Mechanical Engineering Drawing & Graphics.
Problem 1:
Create a complete 3D solid model of the Gripper Rod Center (Exercise 7.36, Page 315 from the textbook). The model must be accurate and fully defined.
Problem 2:
The 3D part file of Stop Base is provided. I need the following:
Add top and right-side orthographic views
Add a full section front view
Add all dimensions in proper standard format and correct locations
Show the 0.62 hole as a limit dimension with sliding tolerance fit using the shaft basis system
Add machined surface finish symbol showing surface roughness average of 25 -in and machining allowance of 0.10 in
Add general tolerance of 0.02 inch in the title block
Add proper notes and complete title block entries
All files must be organized in one folder, zipped, and ready for submission.
Please provide accurate SolidWorks files that are fully editable.
Requirements: Fully
Get this or a similar paper done in as fast as 4 hours, 24/7.
NB: We do not sell prewritten papers. All essays are written from scratch according to specific needs and instructions
Leave a Reply
You must be logged in to post a comment.